CABLE MANAGEMENT (OPTIMISED FOR MFI & TYPE C)

I've tried other similar cable management designs but encountered two issues:

1. The cable openings were too large (about 5.8mm) for MFI/Type C cables.
2. The cable connector (head) wiggled a lot due to the shallow pocket.

In my design, I maintained the same dimensions (approximately 10cmx2cmx1.5cm), but I narrowed the opening to 3.5mm and deepened the pocket for better stability of the cable connector. The wall attached to the table is on the slim end, but I don’t see this as a problem. Still, I thought it was worth mentioning. Friendly reminder: 1. Print Responsibly: Only print when necessary to save money and protect our environment. 2. Reuse and Recycle: Done with your print? Pass it on or recycle it into new filament. 3. Support Creators: Love this design? Show it! Like it, upload your print photos, give feedback (if any), and respect the licensing terms. Your actions can encourage more creative designs for your 3D printer.

X1 Carbon, P1S, P1P, X1, X1E, A1 I simply used the printer's default setting, and it worked well for me. 1 plate 28 min 0.4 mm 12 g PLA